 |
 |
 |
|
80,000 BTU Input Furnace 92% efficient, 1600 cfm, single stage, upflow, natural gas furnace
This Category IV, highly efficient, compact, condensing type furnace is designed for residential and commercial installations in a basement, closet, alcove, recreation room or garage where the ambient temperature is above 32 deg F, or higher. It may be either side wall or thru-roof vented using approved plastic type combustion air and vent piping. All units are factory assembled, wired and tested to assure dependable and economic installation and operation. |
|
|
|
|
|
 |
|
 |
|
Features
- Compact, easy to install, ideal height 40" cabinet.
- Hi-tech tubular aluminized steel primary heat exchanger.
- Secondary (condensing) heat exchanger of 29-4C high-grade stainless steel.
- Electronic Hot Surface Ignition saves fuel cost with increased dependability and reliability.
- 100% shut off main gas valve for extra safety.
- PSC - four speed, direct drive motor with large, quiet blower.
- Built-in, high level self-diagnostics with fault code display.
- May be installed as either two-pipe (sealed combustion) or single-pipe vent (using indoor combustion air)
- Blower-off delay for cooling SEER improvement.
- Easy to connect power/control wiring.
- Low unit amp requirement for easy replacement application.
- Integrated control module for reliable, economical operation.
- Insulated blower compartment for quiet operation.
- Induced combustion system with inshot main burners for quiet, efficient operation.
- No special vent termination kit required.
- 24V, 40 VA control transformer and blower relay supplied for add-on cooling.
- Timed on, adjustable off blower capability for maximum comfort.
- Internal vent coupling for maximum serviceability.
- Solid removable bottom panel allows easy application.
- High velocity filter and filter rack provided for field installation.
|
|
|
 |
|
 |
|
